LHS-100 rigid rod magnetostrictive liquid level gauge, sturdy and reliable, easy to install, without routine maintenance and calibration. Stainless steel measuring rod and floating ball (polytetrafluoroethylene coating can be applied externally in special cases), which are not affected by the physical and chemical properties of the liquid medium to be measured, regardless of the presence of steam, foaming, condensation, foam, boiling, corrosion, etc. in the liquid medium The sensor can not be affected by the situation, or there is a special conductivity, dielectric constant, pressure and vacuum environment, and the liquid level signal can be transmitted stably, accurately and in real time over long distances. The LHS-100 rigid rod magnetostrictive level gauge can be installed directly or through flanges in any common liquid tank and metering equipment. It can provide double float measurement, one float to measure liquid/liquid interface, and one float to measure liquid/vapor interface.

LKS-100 flange-integrated magnetostrictive liquid level gauge electronic warehouse part comes with mounting flange, compact structure, easy installation, suitable for compact installation space occasions, can be installed in common liquid tanks and measuring equipment, the sensor can be 4 M8 screws are directly installed on the flange of the tank mouth; vertical installation is adopted, and the installation slope should be less than 5 degrees; there are various specifications of liquid level floats to choose from, the hemisphere marked by the float should be above the liquid level, and there are measuring rods at both ends of the measuring rod. Dead zone; when the locking ring is fixed, the lower end should be flush with the bottom end of the rod.